Nissan Juke Service and Repair Manual : 4WD warning lamp does not turn off

Description

4WD warning lamp does not turn OFF several seconds after the engine started.

Diagnosis Procedure

1.PERFORM SELF-DIAGNOSIS

Perform self-diagnosis for “ALL MODE AWD/4WD”.With CONSULT-III


Perform self-diagnosis for “ALL MODE AWD/4WD”.

Is any DTC detected? YES >> Check the DTC. Refer to DLN-33, "DTC Index".

NO >> GO TO 2.

2.CHECK 4WD WARNING LAMP

Perform the trouble diagnosis of the 4WD warning lamp. Refer to DLN-80, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the error-detected parts.

3.CHECK 4WD CONTROL MODULE POWER SUPPLY AND GRAUND CIRCUIT

Perform the trouble diagnosis of power supply and ground circuit. Refer to MWI-51, "COMBINATION METER : Diagnosis Procedure".

Is the inspection result normal? YES >> Check each harness connector pin terminal for malfunction or disconnection.

NO >> Repair or replace the error-detected parts.

    4WD warning lamp does not turn on
    Description 4WD warning lamp does not turn ON when the ignition switch is turned to ON. Diagnosis Procedure 1.CHECK 4WD WARNING LAMP Perform the trouble diagnosis for 4WD warning lamp. Refer to DL ...

    Heavy tight-corner braking symptom occurs
    Description Heavy tight-corner braking symptom occurs when the vehicle is driven and the steering wheel is turned fully to either side after the engine is started. NOTE: Light tight-corner bra ...

    Other materials:

    B2013 steering lock unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Lock the steering. NOTE: 3. Press the push-button ignition switch. 4. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Go to SEC-69, & ...

    P1551, P1552 battery current sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. ...

    Timing chain
    Exploded View 1. Timing chain slack guide 2. Timing chain tensioner 3. Timing chain 4. Oil pump drive chain 5. Crankshaft sprocket 6. Crankshaft key 7. Oil pump sprocket 8. Front cover 9. O-ring 10. O-ring 11. Oil control valve cover 12. O-ring 13. Oil control valve (EXH) 14 ...