Nissan Juke Service and Repair Manual : 4WD warning lamp blinks quickly

Description

While driving, 4WD warning lamp blinks 2 times in 1 second and it turns OFF after 1 minute.

NOTE

:
• This symptom protects drivetrain parts when a heavy load is applied to the electric controlled coupling and multiple disc clutch temperature increases. Also, optional distribution of torque sometimes becomes rigid before lamp blinks quickly. Both cases are not malfunction. Refer to DLN-32, "Protection Function".

• When this symptom occurs, stop vehicle and allow it to idle for some times. Blinking will stop and system will be restored.

    Vehicle does not enter 4WD mode
    Description Vehicle does not enter 4-wheel drive mode even though 4WD warning lamp turned to OFF. Diagnosis Procedure 1.CHECK 4WD WARNING LAMP Turn the ignition switch ON. Does 4WD warning la ...

    4WD warning lamp blinks slowly
    Description 4WD warning lamp blinks at approximately 2 seconds intervals while driving. Diagnosis Procedure 1.CHECK TIRE Check the following. • Tire pressure • Wear condition • Front and rear ...

    Other materials:

    System (power door lock system)
    System Diagram System Description DOOR LOCK FUNCTION Door Lock and Unlock Switch • The door lock and unlock switch (driver side) is build into power window main switch. • The door lock and unlock switch (passenger side) is build into front power window switch (passenger side). • Interloc ...

    Wiring diagram
    HEATED SEAT SYSTEM Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...