Nissan Juke Service and Repair Manual : 4WD mode switch
Removal and Installation
REMOVAL
1. Remove instrument lower panel. Refer to IP-12, "Exploded View".
2. Remove 4WD mode switch.
INSTALLATION
Install in the reverse order of removal.
4WD control module
Removal and Installation REMOVAL 1. Turn the ignition switch OFF. 2. Remove front (left side) seat. Refer to SE-27, "Removal and Installation". 3. Remove floor carpet. Refer to INT-23, & ...Unit removal and installation
TRANSFER ASSEMBLY ...Other materials:
Hazard switch
Component Function Check
1.CHECK HAZARD SWITCH SIGNAL BY CONSULT-III
CONSULT-III DATA MONITOR
1. Turn the ignition switch ON.
2. Select “HAZARD SW” of BCM (FLASHER) data monitor item.
3. With operating the hazard switch, check the monitor status.
Is the inspection result normal?
YES >> ...
Wiring diagram
SRS AIR BAG SYSTEM
Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
Floor mats
WARNING
To avoid potential pedal interference that may result in a collision or injury:
• NEVER place a floor mat on top of another floor mat in the driver front
position.
• Use only genuine NISSAN floor mats specifically designed for use in your vehicle
model. See your NISSAN dealer for more ...