Nissan Juke Service and Repair Manual : 4WD mode indicator lamp (4WD-V)
Component Function Check
1.4WD MODE INDICATOR LAMP OPERATION CHECK
1. Turn the ignition switch ON.
2. Change 4WD mode switch to “4WD-V”.
3. Check that 4WD mode indicator lamp (4WD-V) turns on.
Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to diagnosis procedure. Refer to DLN-81, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK 4WD WARNING LAMP
Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.
Does 4WD warning lamp turn ON? YES >> Proceed to DLN-80, "Diagnosis Procedure".
NO >> GO TO 2.
2.CHECK 4WD MODE SWITCH
Perform the trouble diagnosis for 4WD mode switch. Refer to DLN-44, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace the error-detected parts.
3.CHECK 4WD MODE INDICATOR LAMP SIGNAL
With CONSULT-III
1. Start the engine.
CAUTION:
Stop the vehicle.
2. Change 4WD mode switch to “4WD-V” from “2WD”.
3. Check “INDICATOR” of CONSULT-III “DATA MONITOR” for “ALL MODE AWD/4WD”.
Does the item on “DATA MONITOR” indicate “4WD-V”? YES >> GO TO 4.
NO >> Replace 4WD control module. Refer to DLN-91, "Removal and Installation".
4.CHECK COMBINATION METER POWER SUPPLY CIRCUIT
Perform the trouble diagnosis for combination meter power supply circuit. Refer to MWI-51, "COMBINATION METER : Diagnosis Procedure".
Is the inspection result normal? YES >> INSPECTION END
NO >> Repair or replace the error-detected parts.
4WD warning lamp
Component Function Check 1.CHECK 4WD WARNING LAMP FUNCTION 1. Turn the ignition switch ON. 2. Check that 4WD warning lamp turns on. Is the inspection result normal? YES >> INSPECTION END ...4WD mode indicator lamp (4WD)
Component Function Check 1.4WD MODE INDICATOR LAMP OPERATION CHECK Check that 4WD mode indicator lamp (4WD) turns on for approximately 1 second after the ignition switch is turned ON. Is the i ...Other materials:
Symptom diagnosis
COMBINATION SWITCH SYSTEM SYMPTOMS
Symptom Table
1. Perform “Data Monitor” of CONSULT-III to check for any malfunctioning
item.
2. Check the malfunction combinations.
3. Identify the malfunctioning part from the agreed combination and repair or
replace the part.
...
Booster seats
Precautions on booster seats
WARNING
If a booster seat and seat belt are not used properly, the risk of a child
being injured in a sudden stop or collision greatly increases:
• Make sure the shoulder portion of the belt is away from the child’s face
and neck and the lap portion of the belt do ...
Map light control switch (if so equipped)
The map lights control switch has three positions: ON1 , OFF2 and center.
ON position
When the switch is in the ON position 1 , the map lights will illuminate.
OFF position
When the switch is in the OFF position2 , the map lights will not illuminate,
regardless of the condition.
Center posi ...