Nissan Juke Service and Repair Manual : 4WD mode indicator lamp (4WD)
Component Function Check
1.4WD MODE INDICATOR LAMP OPERATION CHECK
Check that 4WD mode indicator lamp (4WD) turns on for approximately 1 second after the ignition switch is turned ON.
Is the inspection result normal? YES >> INSPECTION END
NO >> Proceed to diagnosis procedure. Refer to DLN-82, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK 4WD WARNING LAMP
Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.
Does 4WD warning lamp turn ON? YES >> Proceed to DLN-80, "Diagnosis Procedure".
NO >> GO TO 2.
2.CHECK 4WD MODE SWITCH
Perform the trouble diagnosis for 4WD mode switch. Refer to DLN-44, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace the error-detected parts.
3.CHECK 4WD MODE INDICATOR LAMP SIGNAL
With CONSULT-III
1. Start the engine.
CAUTION:
Stop the vehicle.
2. Change 4WD mode switch to “4WD” from “4WD-V”.
3. Check “INDICATOR” of CONSULT-III “DATA MONITOR” for “ALL MODE AWD/4WD”.
Does the item on “DATA MONITOR” indicate “4WD”? YES >> GO TO 4.
NO >> Replace 4WD control module. Refer to DLN-91, "Removal and Installation".
4.CHECK COMBINATION METER POWER SUPPLY CIRCUIT
Perform the trouble diagnosis for combination meter power supply circuit. Refer to MWI-51, "COMBINATION METER : Diagnosis Procedure".
Is the inspection result normal? YES >> INSPECTION END
NO >> Repair or replace the error-detected parts.
4WD mode indicator lamp (4WD-V)
Component Function Check 1.4WD MODE INDICATOR LAMP OPERATION CHECK 1. Turn the ignition switch ON. 2. Change 4WD mode switch to “4WD-V”. 3. Check that 4WD mode indicator lamp (4WD-V) turns on. ...Other materials:
Exploded View
1. Main muffler
2. Mounting rubber
3. Ring gasket
4. Center tube
5. Exhaust gas temperature sensor 2
6. Diesel particulate filter assembly
7. Gasket
8. Stud bolt
9. Diesel particulate filter inlet tube
10. Gasket
A. To exhaust manifold
B. To pressure hose
: N·m (kg-m, ft-lb)
: ...
Windshield glass
Exploded View
1. Windshield glass molding
2. Dam rubber (upper)
3. Upper clip
4. Windshield glass
5. Dam rubber (lower)
6. Lower clip
7. Mirror base
8. Rain sensor bracket
9. Adhesive
10. Roof panel
11. Headlining assembly
12. Primer
13. Cowl top cover
14. Cowl top panel
1 ...
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT
PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front passenger for certain
types of collision. Information necessary to service the system safely is
include ...