Nissan Juke Service and Repair Manual : Wiper and washer switch
Exploded View
The washer level switch must be replaced together with the washer tank as an assembly. Refer to WW-67, "Removal and Installation".
Light & rain sensor
Exploded View 1. Light & rain sensor bracket 2. Mirror base 3. Light & rain sensor 4. Inside mirror assembly : Pawl : Do not reuse Removal and Installation CAUTION: When the light ...Rear wiper arm
Exploded View 1. Rear wiper motor 2. Rear wiper blade 3. Rear wiper arm 4. Rear wiper arm cover 5. Rear wiper pivot seal A : Model for cold areas : Pawl : N·m (kg-m, in-lb) : N·m (kg-m, ...Other materials:
P0501, P2159 vehicle speed sensor
Description
ECM receives a rear wheel sensor signal from ABS actuator and electric unit
(control unit) via CAN communication
to switch combustion for the direct injection gasoline system. For the direct
injection gasoline system,
refer toEC-48, "DIRECT INJECTION GASOLINE SYSTEM : System ...
Idle neutral control learning
Description
TCM corrects an individual difference in clutch clearance of the transaxle
assembly by performing the idle neutral
control learning and enables accurate idle neutral control.
Therefore, it is required to perform idle neutral control learning after the
following work is performed ...
Operation inspection
Work Procedure
The purpose of the operational check is to check that the individual system
operates normally.
Check condition : Engine running at normal operating temperature.
1.CHECK BLOWER MOTOR
1. Operate fan control dial.
2. Check that fan speed changes. Check operation for all fan speeds ...