Nissan Juke Service and Repair Manual : U1402 engine speed signal
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.PERFORM ECM SELF DIAGNOSIS
Using CONSULT-III, check the “self diagnosis result” of “ENGINE” and repair or replace any malfunctioning parts.
>> • Refer to EC-108, "DTC Index". (MR16DDT) • Refer to EC-522, "DTC Index". (HR16DE) • Refer to EC-855, "DTC Index". (K9K)
U1010 control unit (can)
Description Initial diagnosis of multi display unit DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.REPLACE THE MULTI DISPLAY UNIT If DTC U1010 is detected, replace the multi display unit. ...U1405 engine torque signal
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM ECM SELF-DIAGNOSIS Using CONSULT-III, check the “self diagnosis result” of “ENGINE” and repair or replace any malfunctioning parts. ...Other materials:
Precaution
Precautions for Suspension
• When installing rubber bushings, the final tightening must be carried out
under unladen conditions with tires
on ground. Spilled oil might shorten the life of rubber bushings. Be sure to
wipe off any spilled oil.
- Unladen conditions mean that fuel, engine coolant ...
P0045, P0047, P0048 TC boost control
solenoid valve
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
Performance test
Inspection
INSPECTION PROCEDURE
1. Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold
gauge.
2. Start the engine, and set to the following condition.
Test condition
3. Maintain test condition until A/C system becomes stable. (Approximately 10
minutes)
4. Check t ...