Nissan Juke Owners Manual : Tire and Loading Information label

The cold tire pressure is shown on the Tire and Loading Information label affixed


The cold tire pressure is shown on the Tire and Loading Information label affixed to the pillar as shown.

    Emission control information label
    The emission control information label is attached to the underside of the hood as shown. ...

    Air conditioner specification label
    The air conditioner specification label is attached to the engine compartment as shown. ...

    Other materials:

    P1865 gear ratio signal
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC CONFIRMATION PROCEDURE has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

    Vehicle does not enter 4WD mode
    Description Vehicle does not enter 4-wheel drive mode even though 4WD warning lamp turned to OFF. Diagnosis Procedure 1.CHECK 4WD WARNING LAMP Turn the ignition switch ON. Does 4WD warning lamp turn ON? YES >> GO TO 2. NO >> Proceed to diagnosis procedure. Refer to DLN-80, & ...

    P1778 step motor
    Description The step motor's 4 aspects of ON/OFF change according to the signal from TCM. As a result, the flow of line pressure to primary pulley is changed and pulley ratio is controlled. This diagnosis item is detected when electrical system is OK, but mechanical system is NG. This ...