Cleanliness

Cleanliness RISKS ASSOCIATED WITH CONTAMINATION The high pressure direct injection system is highly sensitive to contamination. The risks associated with contamination are: • damage to or destru ...

Component parts

Component Parts Location ENGINE ROOM COMPARTMENT Top View 1. Priming pump 2. Turbocharger boost control solenoid valve 3. Cooling fan motor 4. Refrigerant pressure sensor 5. IPDM E/R 6. ...

Other materials:

Back door request switch
Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “REQ SW-BD/TR” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Back door req ...

P0730 incorrect gear ratio
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, perform the following procedure to confirm the mal ...

P0504 ASCD brake SWI
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF and wait at least 20 seconds. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO ...