Nissan Juke Service and Repair Manual : System description
Component parts
Component Parts Location POSITION SWITCH 1 : Position switch ...Other materials:
Removal and Installation Procedure for CVT Unit Connector
REMOVAL
Rotate bayonet ring (1) counterclockwise, pull out CVT unit harness
connector (2) upward and remove it.
INSTALLATION
1. Align Δ marking on CVT unit harness connector terminal body
with marking on bayonet ring, insert CVT unit harness connector,
and then rotate bayonet ...
P2100, P2103 throttle control motor relay
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn
ignition switch OFF and wait at
least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following proced ...
Wiper and washer system symptoms
With rain sensor
WITH RAIN SENSOR : Symptom Table
Without rain sensor
WITHOUT RAIN SENSOR : Symptom Table
...