Nissan Juke Owners Manual : Sun visors
TILT OPERATION
Push the lock lever down 1 and adjust the steering wheel up or down 2 to the desired position.
Pull the lock lever up 3 securely to lock the steering wheel in place.
1. To block out glare from the front, swing down the sun visor1 .
2. To block glare from the side, remove the sun visor from the center mount and swing it to the side2 .
Tilt steering column
WARNING
Do not adjust the steering wheel while driving. You could lose control of
your vehicle and cause an accident. ...
Mirrors
...
Other materials:
P1205 exhaust fuel injector
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK EXHAUST FUEL INJECTOR POWER SUPPLY CIRCUIT FOR OPEN AND SHORT
1. Turn ignition switch OFF.
2. Disconnect exhaust fuel injector harness connector.
3. Turn ignition switch ON.
4. Check the voltage between exhaust fuel injector harness ...
P0778 pressure control solenoid B
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn
ignition switch
OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the mal ...
Parts Requiring Angle Tightening
• Use the angle wrench [SST: KV10112100] for the final tightening of the
following engine parts:
- Camshaft sprocket (INT) bolt
- Cylinder head bolts
- Main bearing cap bolts
- Connecting rod cap bolts
- Crankshaft pulley bolt (No the angle wrench is required as bolt flange is
provided with ...