Nissan Juke Service and Repair Manual : Stall Speed

Line Pressure


    Shift Characteristics
    Numerical value data are reference values CAUTION: Lock-up clutch is engaged when vehicle speed is approximately 18 km/h (11 MPH) to 90 km/h (56 MPH). ...

    Line Pressure
    *: Reference values ...

    Other materials:

    P1550 battery current sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. ...

    Removal and Disassembly
    Х When instructed to use SST, use specified tools. Always be careful to work safely, avoid forceful or uninstructed operations. Х Exercise maximum care to avoid damage to mating or sliding surfaces. Х Dowel pins are used for several parts alignment. When replacing and reassembling parts with ...

    Component parts
    Component Parts Location 1. Combination meter Refer to MWI-4, "METER SYSTEM : Component Parts Location". 2. Combination switch (spiral cable) 3. Driver air bag module Crash zone sensor 4. Passenger air bag module 5. Seat belt pre-tensioner LH 6. Satellite sensor LH 7. Lap pr ...