Nissan Juke Service and Repair Manual : Special Service Tool

Commercial Service Tools


    Other materials:

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: Х Before removing and installing any control units, first turn the push-button ignition switch to the LOCK position, then disconnect both battery cables. Х After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. Х Alw ...

    P0841 transmission fluid pressure SEN/SW A
    Description Using the engine load (throttle position), the primary pulley revolution speed, and the secondary pulley revolution speed as input signal, TCM changes the operating pressure of the primary pulley and the secondary pulley and changes the groove width of the pulley to control the ge ...

    P0045, P0047, P0048 TC boost control solenoid valve
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...