Nissan Juke Service and Repair Manual : Special Service Tool
Preparation
...
Other materials:
Parts Requiring Angle Tightening
• Use the angle wrench [SST: KV10112100 (BT8653-A)] for the final tightening
of the following engine parts:
- Camshaft sprocket (INT) bolt
- Cylinder head bolts
- Main bearing cap bolts
- Connecting rod cap bolts
- Crankshaft pulley bolt (No the angle wrench is required as bolt flange is
pr ...
Refilling
1. Remove filler plug (1) and gasket from transaxle case.
2. Fill with new gear oil until oil level reaches the specified limit at
filler plug mounting hole as shown in the figure.
Oil grade and
viscosity
: Refer to MA-13, "Fluids and Lubricants".
Oil capacity : Refer to TM-63, " ...
Flushing
1. Install radiator drain plug.
CAUTION:
Be sure to clean drain plug and install with new O-ring.
Radiator drain plug : Refer to CO-17, "Exploded View".
• If water drain plugs on cylinder block are removed, close and tighten them.
Refer to EM-63, "Setting".
2. Remove a ...