Nissan Juke Service and Repair Manual : Service data and specifications (SDS)

Water outlet
Exploded View 1. Engine coolant temperature sensor 2. O-ring 3. Lock plate 4. Gasket 5. Water outlet and thermostat assembly 6. Air relief plug 7. Clamp 8. Water hose 9. Water pipe A ...

Periodical Maintenance Specification
ENGINE COOLANT CAPACITY (APPROXIMATE) ...

Other materials:

P0131 A/F sensor 1
DTC Logic DTC DETECTION LOGIC To judge the malfunction, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal is not inordinately low. DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ign ...

Reverse idler shaft and gear
Exploded View 1. Reverse output gear 2. Snap ring 3. Reverse baulk ring 4. Return spring 5. Needle bearing 6. Seal washer 7. Reverse idler shaft 8. Spacer 9. Reverse input gear 10. Lock washer 11. Spring washer : Replace the parts as a set. : Always replace after every disass ...

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: Х Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. Х After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. Х Always use CONS ...