Nissan Juke Service and Repair Manual : Service data and specifications (SDS)
Bulb Specifications
*: With intelligent key
Luggage room lamp
Exploded View 1. Bulb housing 2. Bulb 3. Lens : Pawl Removal and Installation CAUTION: Disconnect the battery cable from negative terminal or remove the fuse. REMOVAL 1. Insert a remover ...Wiper & Washer
...Other materials:
Fuel pressure
Work Procedure
FUEL PRESSURE RELEASE
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE” using
CONSULT-III.
3. Start engine.
4. After engine stalls, crank it two or three times to release all fuel
pressure.
5. Turn ignition s ...
Clutch pedal position switch
Component Function Check
1.CHECK FOR CLUTCH PEDAL POSITION SWITCH FUNCTION
1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector and ground.
Is the inspection result normal?
YES >> INSPECTION END.
NO >> Proceed to EC-427, "Diagnosis Procedure" ...
ECM branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the ECM for damage, bend and loose
connection (unit side and
connector side).
Is the inspection result normal?
YES &g ...