Nissan Juke Owners Manual : Safety note

WARNING

• Do not disassemble or modify this system. If you do, it may result in accidents, fire, or electric shock.

• Do not use this system if you notice any abnormality, such as a frozen screen or lack of sound. Continued use of the system may result in accident, fire or electric shock.

• In case you notice any foreign object in the system hardware, spill liquid on it, or notice smoke or smell coming from it, stop using the system immediately and contact your nearest NISSAN dealer. Ignoring such conditions may lead to accidents, fire, or electric shock.

Do not attempt to operate the system in extreme temperature conditions [below −48F (−208C) and above 1588F (708C)].

Operating this system under these conditions may result in system malfunctions.

    Control panel buttons — color screen with navigation system (if so equipped)
    1. (brightness control) button 2. Display screen 3. MAP button 4. NAV button 5. TRAF button 6. SETUP button 7. BACK button 8. TUNE/SCROLL knob 9. Power button/Volume control knob Fo ...

    Other materials:

    B1026, B1027, B1028, B1029, B1030, B1031 diagnosis sensor unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

    General Precautions
    • Always use a 12 volt battery as power source. • Do not attempt to disconnect battery cables while engine is running. • Before connecting or disconnecting the ECM harness connector, turn ignition switch OFF, wait 3 minutes and disconnect battery negative cable. Failure to do so may damage the ...

    Back door opener actuator
    Diagnosis Procedure 1.CHECK BACK DOOR OPENER ACTUATOR INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect back door opener assembly connector. 3. Check voltage between back door opener assembly harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO > ...