Nissan Juke Owners Manual : Removing spots

Remove tar and oil spots, industrial dust, insects, and tree sap as quickly as possible from the paint surface to avoid lasting damage or staining. Special cleaning products are available at a NISSAN dealer or any automotive accessory stores.

    Waxing
    Regular waxing protects the paint surface and helps retain new vehicle appearance. Polishing is recommended to remove built-up wax residue and to avoid a weathered appearance before reapplying wax ...

    Underbody
    In areas where road salt is used in winter, the underbody must be cleaned regularly. This will prevent dirt and salt from building up and causing the acceleration of corrosion on the underbody and ...

    Other materials:

    Drive belt
    Checking Х Inspection should be done only when engine is cold or over 30 minutes after the engine is stopped. 1 : Alternator 2 : Water pump 3 : Crankshaft pulley 4 : A/C compressor 5 : Idler pulley 6 : Drive belt Х Visually check belts for wear, damage, and cracks on inside and edges. ...

    Throttle valve closed position learning
    Description Throttle Valve Closed Position Learning is an operation to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is disconnected. ...

    Precautions on seat belt usage
    If you are wearing your seat belt properly adjusted, and you are sitting upright and well back in your seat with both feet on the floor, your chances of being injured or killed in an accident and/or the severity of injury may be greatly reduced. NISSAN strongly encourages you and all of your p ...