Nissan Juke Service and Repair Manual : Refrigerant pressure sensor
Exploded View
Refer to HA-39, "Exploded View". (HR16DE) Refer to HA-94, "Exploded View". (MR16DDT)
Removal and Installation
REMOVAL
Refer to HA-42, "REFRIGERANT PRESSURE SENSOR : Removal and Installation".
(HR16DE)
Refer to HA-96, "REFRIGERANT PRESSURE SENSOR : Removal and Installation".
(MR16DDT)
INSTALLATION
Install in the reverse order of removal.
Intake sensor
Exploded View Refer to HA-43, "Exploded View (Automatic Air Conditioning)". (HR16DE) Refer to HA-97, "Exploded View (Automatic Air Conditioning)". (MR16DDT) Removal and Installa ...Fan control amplifier
Exploded View 1. A/C unit assembly 2. Fan control amp.*1 3. Blower fan resistor*2 4. Blower motor 5. Blower motor cover • *1: Automatic air conditioner • *2: Manual air conditioner Remova ...Other materials:
P0525 ASCD system
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK GROUND CONNECTIONS
1. Turn ignition switch OFF and wait at least 20 seconds.
2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit
Inspection".
Is the inspection result normal?
YES >> GO TO ...
Sill cover
Exploded View
1. Screw grommet
2. Screw grommet
3. Sill cover
4. Wind defle
Removal and Installation
REMOVAL
1. Remove sill cover front end fixing screw (A).
2. Remove sill cover rear end fixing screw (A).
3. Remove sill cover lower side fixing screws.
4. Fully open front door and ...
P1612 chain of ECM-IMMU
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC P1612 is displayed with DTC U1000 (for BCM), first perform the trouble
diagnosis for DTC U1000.
Refer to BCS-83, "DTC Logic".
• If DTC P1612 is displayed with DTC U1010 (for BCM), first perform the trouble
diagnosis for DTC U1010.
...