Nissan Juke Owners Manual : Inside mirror

Adjust the angle of the inside mirror to the desired position.


Adjust the angle of the inside mirror to the desired position.

The night position1 will reduce glare from the headlights of vehicles behind


The night position1 will reduce glare from the headlights of vehicles behind you at night.

Use the day position2 when driving in daylight hours.

WARNING

Use the night position only when necessary, because it reduces rear view clarity.

    Mirrors
    ...

    Outside mirrors
    WARNING Objects viewed in the outside mirror on the passenger side are closer than they appear. Be careful when moving to the right. Using only this mirror could cause an accident. Use the inside ...

    Other materials:

    B1218, B1219, B1220, B1221, B1222, B1223 diagnosis sensor unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform Self Diagnostic Result mode of AIR BAG using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

    Throttle valve closed position learning
    Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is disconne ...

    Filament
    Inspection and Repair INSPECTION 1. When measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger. 2. Attach probe circuit tester (in Volt range) to middle portion of each filament. 3. If a filament is burned out, circuit ...