Nissan Juke Owners Manual : General maintenance

General maintenance includes those items which should be checked during normal dayto- day operation. They are essential for proper vehicle operation. It is your responsibility to perform these procedures regularly as prescribed.

Performing general maintenance checks requires minimal mechanical skill and only a few general automotive tools.

These checks or inspections can be done by yourself, a qualified technician or, if you prefer, a NISSAN dealer.

    Scheduled maintenance
    For your convenience, both required and optional scheduled maintenance items are described and listed in your NISSAN Service and Maintenance Guide. You must refer to that guide to ensure that ne ...

    Where to go for service
    If maintenance service is required or your vehicle appears to malfunction, have the systems checked and serviced by a NISSAN dealer. NISSAN technicians are well-trained specialists and are kept up- ...

    Other materials:

    Wheel alignment
    Inspection DESCRIPTION Measure wheel alignment under unladen conditions. NOTE: Unladen conditions means that fuel, engine coolant, and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions. PRELIMINARY CHECK Check the following: Tires for improper ai ...

    P160C ECM
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON and perform the self-diagnosis. Is the DTC P160C displayed again? YES >> GO TO 2. NO &g ...

    Additional service when replacing control unit
    ECM ECM : Description Performing the following procedure can automatically activate recommunication of ECM and BCM, but only when the ECM is replaced with a new one*. *: New one means a virgin ECM that has never been energized on-board. (In this step, initialization procedure by CONSULT-I ...