Nissan Juke Owners Manual : Fuel Efficient Driving Tips

Follow these easy-to-use Fuel Efficient Driving Tips to help you achieve the most fuel economy from your vehicle.

1. Use smooth accelerator and brake pedal application.

  Avoid rapid starts and stops.

  Use smooth, gentle accelerator and brake application whenever possible.

  Maintain constant speed while commuting and coast whenever possible.

2. Maintain constant speed.

  Look ahead to try and anticipate and minimize stops.

  Synchronizing your speed with traffic lights allows you to reduce your number of stops.

  Maintaining a steady speed can minimize red light stops and improve fuel efficiency.

3. Use air conditioning (A/C) at higher vehicle speeds.

Below 40 MPH (64 km/h), it is more efficient to open windows to cool the vehicle due to reduced engine load.

  Above 40 MPH (64 km/h), it is more efficient to use A/C to cool the vehicle due to increased aerodynamic drag.

Recirculating the cool air in the cabin when the A/C is on reduces cooling load.

4. Drive at economical speeds and distances.

Observing the speed limit and not exceeding 60 MPH (97 km/h) (where legally allowed) can improve fuel efficiency due to reduced aerodynamic drag.

  Maintaining a safe following distance behind other vehicles reduces unnecessary braking.

Safely monitoring traffic to anticipate changes in speed permits reduced braking and smooth acceleration changes.

Select a gear range suitable to road conditions.

5. Use cruise control.

  Using cruise control during highway driving helps maintain a steady speed.

Cruise control is particularly effective in providing fuel savings when driving on flat terrains.

6. Plan for the shortest route.

  Utilize a map or navigation system to determine the best route to save time.

7. Avoid idling.

  Shutting off your engine when safe for stops exceeding 30-60 seconds saves fuel and reduces emissions.

8. Buy an automated pass for toll roads.

  Automated passes permit drivers to use special lanes to maintain cruising speed through the toll and avoid stopping and starting.

9. Winter warm up.

  Limit idling time to minimize impact to fuel economy.

  Vehicles typically need no more than 30 seconds of idling at start-up to effectively circulate the engine oil before driving.

Your vehicle will reach its ideal operating temperature more quickly while driving versus idling.

10. Keeping your vehicle cool.

  Park your vehicle in a covered parking area or in the shade whenever possible.

When entering a hot vehicle, opening the windows will help to reduce the inside temperature faster, resulting in reduced demand on your A/C system.

    Break-in schedule
    CAUTION During the first 1,200 miles (2,000 km), follow these recommendations to obtain maximum engine performance and ensure the future reliability and economy of your new vehicle. Failure to fo ...

    Increasing fuel economy
    Keep your engine tuned up. Follow the recommended scheduled maintenance. Keep the tires inflated to the correct pressure. Low tire pressure increases tire wear and lowers fuel economy. Ke ...

    Other materials:

    Handling precaution
    NISSAN Dynamic Control System The engine torque, engine power, boost pressure, and instantaneous fuel consumption are provided for information purposes only. They are not intended to prompt the driver to adjust driving style. The readings may be slightly delayed relative to the actual vehic ...

    G sensor
    Exploded View 1. G sensor : Vehicle front : Nm (kg-m, in-lb) Removal and Installation CAUTION: Never drop or strike G sensor, because it has little tolerance for impact. Never use a power tool to avoid impact. REMOVAL 1. Disconnect the battery cable from the negative terminal. Refer ...

    Removal and Installation Procedure for CVT Unit Connector
    REMOVAL Rotate bayonet ring (1) counterclockwise, pull out CVT unit harness connector (2) upward and remove it. INSTALLATION 1. Align Δ marking on CVT unit harness connector terminal body with 􀂆 marking on bayonet ring, insert CVT unit harness connector, and then rotate bayonet ...