Nissan Juke Service and Repair Manual : Fuel

Gasoline engine (model with three-way catalyst)

CAUTION: Do not use leaded gasoline. Using leaded gasoline will damage the three-way catalyst.

Use unleaded premium gasoline of at least 95 octane (RON).

If unleaded premium gasoline is not used, unleaded regular gasoline with an octane rating of at least 91 (RON) may be used at slightly reduced performance. However, for maximum vehicle performance and the best driveability, the use of unleaded premium gasoline is recommended.

    Air Conditioning
    Use an approved refrigerant recovery unit any time the air conditioning system must be discharged. Refer to HA section “REFRIGERATION SYSTEM” for specific instructions. ...

    Other materials:

    How to select piston and bearing
    Description • The identification grade stamped on each part is the grade for the dimension measured in new condition. This grade cannot apply to reused parts. • For reused or repaired parts, measure the dimension accurately. Determine the grade by comparing the measurement with the values o ...

    Line pressure test
    Work Procedure INSPECTION 1. Check the engine oil level. Replenish if necessary. LU-25, "Inspection". 2. Check for leak of the CVT fluid. Refer to TM-480, "Inspection". 3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80°C (122 ...

    Additional service when replacing transaxle assembly
    Description Perform the following work after the transaxle assembly is replaced. Erasing the calibration data • The TCM acquires calibration data (individual characteristic value) of each solenoid that is stored in the ROM assembly (in the control valve). This enables the TCM to perform accu ...