Nissan Juke Owners Manual : Emergency engine shut off (models with Intelligent Key system)

To shut off the engine in an emergency situation while driving, perform the following procedure:

Rapidly push the push-button ignition switch 3 consecutive times in less than 1.5 seconds, or
Push and hold the push-button ignition switch for more than 2 seconds.

    Hazard warning flasher switch
    Push the switch on to warn other drivers when you must stop or park under emergency conditions. All turn signal lights will flash. WARNING   If stopping for an emergency, be sure to move ...

    Flat tire
    ...

    Other materials:

    PTC heater control unit connection recognition signal circuit
    Diagnosis Procedure 1.CHECK PTC HEATER CONTROL UNIT CONNECTION RECOGNITION SIGNAL 1. Turn ignition switch ON. 2. Check voltage between combination meter harness connector and ground. Is the inspection result normal? YES >> INSPECTION END NO >> GO TO 2. 2.CHECK PTC HEATER CONTR ...

    P0826 up and down shift SW
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If DTC CONFIRMATION PROCEDURE has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. After the repair, p ...

    Brake pedal vibration or operation sound occurs
    Description Brake pedal vibrates and motor sound from ABS actuator and electric unit (control unit) occurs, when the engine starts. Brake pedal vibrates during braking. CAUTION: Vibration may be felt during brake pedal is lightly depressed (just placing a foot on it) in the following ...