Nissan Juke Owners Manual : Continuously Variable Transmission (CVT) position indicator (if so equipped)

The Continuously Variable Transmission (CVT) position indicator indicates the shift lever position when the ignition switch is in the ON position.

    Outside air temperature
    The outside air temperature is displayed in 8F or 8C. When the outside air temperature becomes 378F (38C) or lower, the outside air temperature display blinks to give a warning. The display will st ...

    Trip computer
    The switch for the trip computer is located on the meter panel. When the ignition switch is placed in the ON position, modes of the trip computer can be selected by pushing the trip computer mode ...

    Other materials:

    On Board Diagnostic (OBD) System of Engine and CVT
    The ECM has an on board diagnostic system. It will light up the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration. CAUTION: Х Be sure to turn the ignition switch OFF and disconnect the negative battery cable before any repair or inspection ...

    Power supply and ground circuit
    Diagnosis Procedure 1.CHECK FUSES AND FUSIBLE LINK Check that the following IPDM E/R fuses or fusible links are not blown. Is the fuse fusing? YES >> Replace the blown fuse or fusible link after repairing the affected circuit if a fuse or fusible link is blown. NO >> GO TO 2. ...

    Draining
    1. Start engine and let it run to warm up transaxle. 2. Stop engine. Remove drain plug (1) and gasket, using a socket [Commercial service tool] and then drain gear oil. 3. Set a gasket on drain plug and install it to clutch housing, using a socket [Commercial service tool]. CAUTION: Never re ...