Nissan Juke Owners Manual : Battery saver system

When all the following conditions are met for a period of time, the battery saver system will cut off the power supply to prevent battery discharge.

Х The ignition switch is in the ACC position, and Х All doors are closed, and Х The shift lever is in the P (Park) position (Continuously Variable Transmission models).

    Intelligent Key operation
    You can lock or unlock the doors without taking the key out from your pocket or bag. When you carry the Intelligent Key with you, you can lock or unlock all doors by pushing the door handle ...

    Warning lights and audible reminders
    To help prevent the vehicle from moving unexpectedly by erroneous operation of the Intelligent Key listed on the following chart or to help prevent the vehicle from being stolen, chime or beep sou ...

    Other materials:

    Engine oil
    Inspection ENGINE OIL LEVEL NOTE: Before starting engine, put vehicle horizontally and check the engine oil level. If engine is already started, stop it and allow 10 minutes before checking. 1. Pull out oil level gauge and wipe it clean. 2. Insert oil level gauge and check that the engine ...

    P1550 battery current sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. ...

    Precaution for Liquid Gasket
    REMOVAL OF LIQUID GASKET Х After removing the mounting bolts and nuts, separate the mating surface using a seal cutter and remove the liquid gasket. CAUTION: Be careful not to damage the mating surfaces. Х In areas where the cutter is difficult to use, use a plastic hammer to lightly tap the ...