Nissan Juke Service and Repair Manual : Basic inspection

Wiring diagram
BRAKE CONTROL SYSTEM Wiring Diagram For connector terminal arrangements, harness layout, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connec ...

Diagnosis and repair work flow
Work Flow DETAILED FLOW 1.INTERVIEW FROM THE CUSTOMER Clarify customer complaints before inspection. First of all, perform an interview utilizing BRC-146, "Diagnostic Work Sheet" and r ...

Other materials:

P0409 EGR volume control valve control position sensor
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or ...

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: Х Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. Х After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. Х Always use CONS ...

P0744 torque converter
Description This malfunction is detected when the torque converter clutch does not lock-up as instructed by the TCM. This is not only caused by electrical malfunction (circuits open or shorted), but also by mechanical malfunction such as control valve sticking, improper solenoid valve operati ...